Clenbuterol – Best Fat Burner in Bodybuilding?

clenbuterol bodybuilding

Clenbuterol, a.k.a clen is a sympathomimetic amine which was originally produced for the treatment of asthma. The drug is now hugely popular in bodybuilding, being craved by gym-goers for its excellent fat burning and muscle retaining qualities. Clen raises your body’s internal temperature, which results in the increase of your basic metabolic rate (BMR).

As your metabolic rate increases, your body responds by burning stored fat first before any other fuel source. As a result, you end up burning calories more quickly whilst reducing your body fat percentage. With the help of clen, you could potentially have the amazingly ripped body you’ve always dreamed of.

clen bodybuilding

In bodybuilding, Clenbuterol performs best when taken before a workout because it give you explosive energy while improving your stamina/endurance. The supplement is also known to increase oxygen flow in your body, boosting your cardiovascular performance as well. You’ll realize that your body is able to undergo more intense and longer workouts after only a few days of use.

Clenbuterol is much regarded as the best and most powerful fat burner in bodybuilding. But what’s the best way to use clen in order to maximize fat loss and preserve your hard-earned muscle mass? The 3 clenbuterol cycles below will reveal all!

3 Most Popular Clenbuterol Cycles in Bodybuilding

There are various ways of planning a Clenbuterol cycle. Among them, three stand out as the most common protocols, while two are thought to be the most effective.

Of these two, there’s one in particular which is superior. But first, the three most common Clen cycles include:

• Two days on/Two days off (Bursting Clenbuterol Cycle)
• Two weeks on/Two weeks off (The Most Common Cycle)
• Continuous use with increasing dose (Incrementing Clenbuterol Cycle)

Now I’m going to discuss the three above cycles, so you’ll be able to see which one is best for you. However, regardless of the cycle you choose, there’s likely to be one protocol that your body responds exceptionally well to, so it’s recommended to experiment with each different strategy.

Bursting Clenbuterol Cycle 

The two day on/two days off cycle is known in bodybuilding as a bursting cycle. The idea is to blast clen for two days with a considerably high dose followed by nothing for two days. Then a bodybuilder will repeat the cycle again.

The bursting cycle can be utilized for months on end, but this is not the most popular method since it doesn’t stay in your system long enough to maximize fat burning (according to most bodybuilders).

Admittedly, of the three cycles – this cycle is proven to be the most strenuous and ineffective. A cycle like this causes a lot of stress on the body as there’s no sufficient time for it to adapt.

Two Weeks On/Two Weeks Off Clenbuterol Cycle

For decades, this method has been the most famous among bodybuilders. Practically, it’s a more effective cycle as far as fat-burning goes, compared to the bursting method. In general, this kind of cycle may be a little more complex for newbie bodybuilders to follow. You’re required to start the cycle with a smaller dose, typically in the range of between 20mcg and 40mcg.

Then you simply increase your dosage every day or two until you reach the maximum desired dose; which often falls between 100mcg and 140mcg. You then stop using the drug after 2 weeks of continuous use.

With the half-life of clenbuterol being between 36 and 48 hours, it can remain elevated in your system for many days after the two weeks admission. This is something you have to remember when planning an efficient Clen cycle. With the long half-life of the drug, taking just a few days off won’t allow sufficient time for the up-regulation of your body’s receptors. So, you should take a minimum of 14 days off in-between two-week cycles.

When you start your second cycle after the two week break, you may begin with a higher dose as your body will be more used to the drug. So, you could start with say 80mcg on the first day, then increase the dosage each day until you reach your maximum dose of 120-140mcg.

While this is the most popular cycle, the incrementing clenbuterol cycle is also popular amongst newbies because it results in awesome fat loss and is less complex than this method.

Incrementing Clenbuterol Cycle

While not as famous as the two weeks on/two weeks off cycle, the incremental cycle has been gaining popularity quickly over recent years and for good reason – it’s simple and very effective.

This plan is just a piece-of-cake; you start at a low dose, typically in the 20mcg-40mcg range and increase the dose by 20mcg every two weeks. This cycle allows a person to experience the awesome fat burning effects of Clenbuterol by maintaining an extremely revved up metabolism for a longer period of time. Bodybuilders will use this method for up to 8 weeks and will only do a couple of these cycles a year; usually when prepping for a show or trying to get shredded for the beach.

Clenbuterol: Bodybuilding’s Best Cutting Supplement?

Wouldn’t you love to take a supplement and effortlessly burn fat, whilst keeping all your muscle? Do you crave for a tablet which provides you with maximum energy and endurance when on low calories? Any gym-goer would undoubtedly love this to be their reality by swallowing a few tablets.

Many celebrities are already using clenbuterol because of its amazing fat burning effects, enabling them to make incredible transformations for movies. When compared to other thermogenics, Clenbuterol is up to 3 times more powerful than other famous cutting agents such as – Ephedrine. I think that puts into perspective how formidable clenbuterol is.

Be the first to comment

Leave a Reply

Your email address will not be published.


*